Leader LV5300A - Page 411

16. Status Display
394
Set F•1 DID and F•2 SDID/DBN to display ancillary packets on the basis of the
combination of the DID and SDID/DBN.
You can set F•1 DID in the range of 00 to FF. Press the function dial (F•D) to return the
setting to its default value (00).
You can set F•2 SDID/DBN in the range of 00 to FF or select “--” to not specify a value.
Press the function dial (F•D) to return the setting to its default value (--).
Press F•3 SET to clear the blue cursor assigned to F•1 DID or F•2 SDID/DBN. Use this
key when you want to view all the data using the function dial (F•D).
• Selecting the Dump Mode
You can use F•2 DUMP MODE to set the dump mode to HEX (hexadecimal display) or
BINARY (binary display).
• Selecting Which Signal to Display
When the input signal is not SD, you can use F•3 Y/C SELECT to set the signal to display
to Y signal or C signal.
• Selecting the Displayed Stream
When the input signal is 3G-B, to set the display stream to STREAM1 or STREAM2, press
F•4 STREAM SELECT.
• Selecting the Content to Display
You can select the displayed content using F•5 LINK when the input signal is multi link
and F•5 SUB when the input signal is 6G and 12G.