Leader LV5300A - Page 485

19. Network Control
468
4. On the PC, start an SNMP manager.
You must provide the SNMP manager yourself.
The default community names are shown below.
ReadOnly and ReadWrite can be changed with the SNMP Community parameter.
[See also] SNMP Community → 7.2.9, “Configuring SNMP”
ReadOnly: LDRUser
ReadWrite: LDRAdm
TRAP: LDRUser
5. Check that the SNMP managers can perform GET and SET operations.
6. From the SNMP manager, set the following MIB items to the SNMP managers’ IP
addresses.
Up to four locations can be set.
[IP address of TRAP transmission destination 1]
1.3.6.1.4.1.leader(20111).lv5300(40).lv5300ST1(1).l40trapTBL(9).l40trapIpTBL(1).l40t
rapIp1TBL(1).l40trapManagerIp1(1).0
[IP address of TRAP transmission destination 2]
1.3.6.1.4.1.leader(20111).lv5300(40).lv5300ST1(1).l40trapTBL(9).l40trapIpTBL(1).l40t
rapIp2TBL(2).l40trapManagerIp1(1).0
[IP address of TRAP transmission destination 3]
1.3.6.1.4.1.leader(20111).lv5300(40).lv5300ST1(1).l40trapTBL(9).l40trapIpTBL(1).l40t
rapIp3TBL(3).l40trapManagerIp1(1).0
[IP address of TRAP transmission destination 4]
1.3.6.1.4.1.leader(20111).lv5300(40).lv5300ST1(1).l40trapTBL(9).l40trapIpTBL(1).l40t
rapIp4TBL(4).l40trapManagerIp1(1).0
7. Enable the TRAP transmission destinations.
To alleviate communication load, disable the transmission destinations that you are not
using. This setting is disabled by factory default.
[Enable (1) or disable (2) TRAP transmission destination 1]
1.3.6.1.4.1.leader(20111).lv5300(40).lv5300ST1(1).l40trapTBL(9).l40trapIpTBL(1).l40t
rapIp1TBL(1).l40trapManagerIp1Act(2).0
[Enable (1) or disable (2) TRAP transmission destination 2]
1.3.6.1.4.1.leader(20111).lv5300(40).lv5300ST1(1).l40trapTBL(9).l40trapIpTBL(1).l40t
rapIp2TBL(2).l40trapManagerIp1Act(2).0
[Enable (1) or disable (2) TRAP transmission destination 3]
1.3.6.1.4.1.leader(20111).lv5300(40).lv5300ST1(1).l40trapTBL(9).l40trapIpTBL(1).l40t
rapIp3TBL(3).l40trapManagerIp1Act(2).0
[Enable (1) or disable (2) TRAP transmission destination 4]
1.3.6.1.4.1.leader(20111).lv5300(40).lv5300ST1(1).l40trapTBL(9).l40trapIpTBL(1).l40t
rapIp4TBL(4).l40trapManagerIp1Act(2).0