• Ver. 4.1
• Minor changes
• Ver. 4.0
• Minor changes
• Ver. 3.9
• [LV5300/LV5350/LV7300-SER01/LV7300-SER02] Added an SR Live analysis display to the
status.
• [LV5300/LV5350/LV7300-SER01/LV7300-SER02] Added the marker display supported the
BT.709 color bar of the color gamut of ARIB STD-B66 and ARIB STD-B72 to the vector.
(When VARIABLE SCALE is set to on and the color gamut is detected as BT.2020, this is
valid.)
• [SER21] English closed caption (EIA 708/608) now supports 4K-6G system.
• Ver. 3.8
• Minor changes
• Ver. 3.7
• Minor changes
• Ver. 3.6
• [LV5300/LV5350/LV7300] Improved so that the assigned address is displayed when DHCP is
selected on the SYSTEM SETUP NETWORK tab menu.
• [SER21] English closed caption (EIA-608) now supports multiple formats. (3G-A, 3G-B-DL,
4K Dual, 4K 12G)
• Ver. 3.3
• [LV5300/LV5350/LV7300] Added DDR3 and scaler initialization because, in rare cases, the
measurement screen did not appear after startup.
• [LV5300/LV5350/LV7300-SER01/LV7300-SER02] Fix a problem that was causing a TRS
error and line number error to occur in rare cases after SDI signal detection.
• [SER20] Improved so that the display of the peak hold value and the instantaneous value
can be switched on the meter display.
• Ver. 3.0
• [LV5300/LV5350/LV7300] Improved so that 1080/48P and 1080/47.95P can be selected for
MONITOR OUT.
• [LV5300/LV5350/LV7300-SER01/LV7300-SER02] For AV PHASE of status, the AV PHASE
SETUP menu was changed from F6 to F3, and the INPUT SELECT menu was added to F6.
• [SER26] Custom layout now supports AV PHASE.
• Ver. 2.8
• [LV5300/LV5350/LV7300] Improved so that the waveform color can be specified when the
capture is held.
• [LV5300/LV5350/LV7300-SER01/LV7300-SER02] Variable scale is now supported for
composite signals on the vector waveform display.
• [LV5300/LV5350/LV7300-SER01/LV7300-SER02] Marker display is now supported for the
guide display on the vector waveform display.
To Next Page
Loading...
