Dell MXL 10GbE - Show Crypto Ipsec Policy

show crypto ipsec policy
Display the configuration of IPsec authentication and encryption policies.
Syntax show crypto ipsec policy [name name]
Parameters
name name (OPTIONAL) Displays configuration details about a specified
policy.
Defaults none
Command
Modes
EXEC
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The show crypto ipsec policy command output displays the AH and ESP
parameters configured in IPsec security policies, including the SPI number, keys,
and algorithms used.
When configured in a helper-reject role, an OSPFv3 router ignores the Grace LSAs
that it receives from a restarting OSPFv3 neighbor.
show crypto ipsec sa ipv6
Display the IPsec security associations (SAs) used on OSPFv3 interfaces.
Syntax
show crypto ipsec sa ipv6 [interface interface]
Parameters
interface
interface
(OPTIONAL) Displays information about the SAs used on a
specified OSPFv3 interface, where interface is one of the
following values:
• For a 1-Gigabit Ethernet interface, enter
GigabitEthernet then the slot/part number.
• For a Port Channel interface, enter port-channel then
the port channel number.
• For a 10-Gigabit Ethernet interface, enter
TenGigabitEthernet then the slot/port number.
• For a 40–Gigabit Ethernet interface, enter fortyGigE
then the slot/port number.
• For a VLAN interface, enter vlan vlan-id. The valid
VLAN IDs range is from 1 to 4094.
1000
Open Shortest Path First (OSPFv2 and OSPFv3)