Dell MXL 10GbE - Iscsi Enable

dscp dscp-
value
Enter the DSCP value assigned to the incoming packets in an
iSCSI session. The valid range is from 0 to 63. The default is:
the DSCP value in ingress packets is not changed.
remark Marks the incoming iSCSI packets with the configured dot1p
or DSCP value when they egress to the switch. The default is:
the dot1and DSCP values in egress packets are not changed.
Defaults The default dot1p VLAN priority value is 4 without the remark option.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
iscsi enable
Globally enable iSCSI optimization.
Syntax
iscsi enable
To disable iSCSI optimization, use the no iscsi enable command.
Parameters
enable Enter the keyword enable to enable the iSCSI optimization
feature.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you enable the iSCSI feature using the iscsi enable command, flow
control settings are set to rx on tx off on all interfaces.
iscsi priority-bits
Configure the priority bitmap that advertises in the iSCSI application TLVs.
Syntax
iscsi priority-bits
To remove the configured priority bitmap, use the no iscsi priority-bits
command.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
1461