When creating Confederations, all the routers in the Confederation must be 4- or
2-byte identified routers. You cannot mix them.
Where the 2-Byte format is from 1 to 65535, the 4-Byte format is from 1 to
4294967295. Both formats are accepted, and the advertisements reflect the
entered format.
For more information about using the 2- or 4-Byte format, refer to the Dell
Networking OS Configuration Guide.
bgp graceful-restart
Enable graceful restart on a BGP neighbor, a BGP node, or designate a local router to support graceful
restart as a receiver only.
Syntax
bgp graceful-restart [restart-time seconds] [stale-path-time
seconds] [role receiver-only]
To return to the default, enter the no bgp graceful-restart command.
Parameters
neighbor ip-
address | peer-
group-name
Enter the keyword neighbor then one of the options:
• ip-address of the neighbor in IP address format of the
neighbor
• peer-group-name of the neighbor peer group
restart-time
seconds
Enter the keywords restart-time then the maximum
number of seconds needed to restart and bring up all peers.
The range is from 1 to 3600 seconds. The default is 120
seconds.
stale-path-time
seconds
Enter the keywords stale-path-time then the maximum
number of seconds to wait before restarting a peer’s stale
paths. The default is 360 seconds.
role receiver-
only
Enter the keywords role receiver-only to designate the
local router to support graceful restart as a receiver only.
Defaults As above
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This feature is advertised to BGP neighbors through a capability advertisement. In
Receiver Only mode, BGP saves the advertised routes of peers that support this
capability when they restart.
IPv6 Border Gateway Protocol (IPv6 BGP)
703
To Next Page
Loading...
