Dell MXL 10GbE - Capture Bgp-Pdu Neighbor (Ipv6)

Command
Modes
ROUTER BGPV6 ADDRESS FAMILY (conf-router_bgpv6_af)
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you enable soft-reconfiguration for a neighbor and you execute the clear
ip bgp soft in command, the update database stored in the router replays and
updates are reevaluated. With this command, the replay and update process is
triggered only if route-refresh request is
not negotiated with the peer. If the
request is negotiated (after execution of clear ip bgp soft in), BGP sends a
route-refresh request to the neighbor and receives all of the peer’s updates.
Related
Commands
clear ip bgp ipv6 unicast soft — activates inbound policies for IPv6 routes without
resetting the BGP TCP session.
capture bgp-pdu neighbor (ipv6)
Enable capture of an IPv6 BGP neighbor packet.
Syntax
capture bgp-pdu neighbor ipv6-address direction {both | rx |
tx}
To disable capture of the IPv6 BGP neighbor packet, use the no capture bgp-
pdu neighbor ipv6-address command.
Parameters
ipv6-address Enter the IPv6 address of the target BGP neighbor.
direction {both
| rx | tx}
Enter the keyword direction and a direction — either rx
for inbound, tx for outbound, or both.
Defaults Not configured.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
capture bgp-pdu max-buffer-size — enables route reflection between the route
reflector and the clients.
show capture bgp-pdu neighbor — configures a route reflector and clients.
IPv6 Border Gateway Protocol (IPv6 BGP)
707