Dell MXL 10GbE - Link Aggregation Control Protocol (LACP)

29
Link Aggregation Control Protocol (LACP)
This chapter contains commands for Dell Networks’s implementation of the link aggregation control
protocol (LACP) for creating dynamic link aggregation groups (LAGs) — known as port-channels in the
Dell Networking Operating System (OS).
NOTE: For static LAG commands, refer to the Interfaces chapter), based on the standards specified
in the IEEE 802.3 Carrier sense multiple access with collision detection (CSMA/CD) access method
and physical layer specifications.
clear lacp counters
Clear port channel counters.
Syntax
clear lacp port-channel-number counters
Parameters
port-channel-
number
Enter a port-channel number. The range is from 1 to 128.
Defaults Without a Port Channel specified, the command clears all Port Channel counters.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
show lacp — displays the LACP configuration.
debug lacp
Debug LACP (configuration, events, and so on).
Syntax
debug lacp [config | events | pdu [interface [in | out]]]
To disable LACP debugging, use the no [config | events | pdu
[
interface [in | out]]] command.
Parameters
config (OPTIONAL) Enter the keyword config to debug the LACP
configuration.
840
Link Aggregation Control Protocol (LACP)