To use the closest interface, use the no neighbor {ip-address | peer-
group-name} update-source interface command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal
format.
peer-group-
name
Enter the name of the peer group to disable all routers within
the peer group.
interface Enter the keyword loopback then a number of the
Loopback interface. The range is from 0 to 16383.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Loopback interfaces are up constantly and the BGP session may need one
interface constantly up to stabilize the session. The neighbor update-source
command is not necessary for directly connected internal BGP sessions.
neighbor weight
Assign a weight to the neighbor connection, which is used to determine the best path.
Syntax
neighbor {ip-address | peer-group-name} weight weight
To remove a weight value, use the no neighbor {ip-address | peer-
group-name
} weight command.
Parameters
ip-address Enter the IP address of the peer router in dotted decimal
format.
peer-group-
name
Enter the name of the peer group to disable all routers within
the peer group.
weight Enter a number as the weight. The range is from 0 to 65535.
The default is 0.
Defaults 0
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
356
Border Gateway Protocol IPv4 (BGPv4)
To Next Page
Loading...
