Dell MXL 10GbE - Interfaces

21
Interfaces
The commands in this chapter are supported by Dell Networking Operating System (OS).
This chapter contains the following sections:
• Basic Interface Commands
• Port Channel Commands
Basic Interface Commands
The following commands are for Physical, Loopback, and Null interfaces.
clear counters
Clear the counters used in the show interfaces commands for all virtual router redundancy protocol
(VRRP) groups, virtual local area networks (VLANs), and physical interfaces, or selected ones.
Syntax
clear counters [interface] [vrrp [{vrid | vrf instance}]|
learning-limit]
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/
port or number to clear counters from a specified interface:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For the management interface on the RPM, enter the
keyword ManagementEthernet then slot/port
information. The slot range is from 0 to 1 and the port
range is 0.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword VLAN then a number from
1 to 4094.
vrrp vrid] (OPTIONAL) Enter the keyword vrrp to clear the counters of
all VRRP groups. To clear the counters of a specified group,
enter a VRID number from 1 to 255.
Interfaces
553