Dell MXL 10GbE - Lacp Ungroup Member-Independent Vlt

lacp ungroup member-independent vlt
Prevent possible loop during the bootup of a VLT peer switch or a device that accesses the VLT domain.
Syntax
lacp ungroup member-independent vlt
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
LACP on the VLT ports (on a VLT switch or access device), which are members of
the virtual link trunk, is not brought up until the VLT domain is recognized on the
access device.
multicast peer-routing timeout
Configure the time for a VLT node to retain synced multicast routes or synced multicast outgoing
interface (OIF) after a VLT peer node failure.
Syntax
multicast peer-routing timeout value
To restore the default value, use the no multicast peer-routing timeout
command.
Parameters
value Enter the timeout value in seconds. The range is from 1 to
1200. The default is 150.
Default Not configured.
Command
Modes
VLT DOMAIN (conf-vlt-domain)
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
peer-link port-channel
Configure the specified port channel as the chassis interconnect trunk between VLT peers in the domain.
Syntax
peer-link port-channel id-number
Parameters
id-number Enter the port-channel number that acts as the interconnect
trunk. The range is from 1 to 128.
Virtual Link Trunking (VLT)
1333