Dell MXL 10GbE - Policy-Map-Input

policy-map-input
Create an input policy map.
Syntax
policy-map-input policy-map-name [layer2]
To remove an input policy map, use the no policy-map-input policy-map-
name [layer2] command.
Parameters
policy-map-
name
Enter the name of the policy map in character format (32
characters maximum).
layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2
Class Map. The default is
Layer 3.
Defaults Layer 3
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The input policy map is used to classify incoming traffic to different flows using
class-map, QoS policy, or incoming packets DSCP. This command enables Policy-
Map-Input Configuration mode (conf-policy-map-in).
Related
Commands
service-queue — assigns a class map and QoS policy to different queues.
policy-aggregate — allows an aggregate method of configuring per-port QoS
using policy maps.
service-policy input — applies an input policy map to the selected interface.
policy-map-output
Create an output policy map.
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name
command.
Parameters
policy-map-
name
Enter the name for the policy map in character format (32
characters maximum).
Quality of Service (QoS)
1089