Dell MXL 10GbE - Multi-Topology

Parameters
narrow Allows you to generate and accept old-style TLVs. The
metric range is from 0 to 63.
transition Allows you to generate both old-style and new-style TLVs.
The metric range is from 0 to 63.
wide Allows you to generate and accept only new-style TLVs. The
metric range is from 0 to 16777215.
level-1 Enables the metric style on Level 1.
level-2 Enables the metric style on Level 2.
Defaults narrow; if no Level is specified, Level-1 and Level-2 are configured.
Command
Modes
ROUTER ISIS
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you enter the metric-style wide command, the system generates and
accepts only new-style TLVs. The router uses less memory and other resources
rather than generating both old-style and new-style TLVs.
The new-style TLVs have wider metric fields than old-style TLVs.
Related
Commands
isis metric — configures a metric for an interface.
multi-topology
Enables multi-topology IS-IS. It also allows enabling/disabling of old and new style TLVs for IP prefix
information in the LSPs.
Syntax
multi-topology [transition]
To return to a single topology configuration, use the no multi-topology
[transition] command.
Defaults Disabled
Command
Modes
CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
822
Intermediate System to Intermediate System (IS-IS)