EasyManua.ls Logo

Dell MXL 10GbE - Ipv6 Nd Prefix

Dell MXL 10GbE
1545 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ipv6 nd prefix
Specify which IPv6 prefixes are included in Neighbor Advertisements.
Syntax
ipv6 nd prefix {ipv6-prefix | prefix-length | default} [no-
advertise] | [no-autoconfig] [no-rtr-address] [off-link]
[lifetime {valid | infinite} {preferred | infinite}]
Parameters
ipv6-prefix Enter an IPv6 prefix.
prefix-length Enter the prefix then the prefix length. The length range is
from 0 to 128.
default Enter the keyword default to set default parameters for all
prefixes.
no-advertise Enter the keyword no-advertise to prevent the specified
prefix from being advertised.
no-autoconfig Enter the keywords no-autoconfig to disable Stateless
Address Autoconfiguration.
no-rtr-address Enter the keyword no-rtr-address to exclude the full
router address from router advertisements (the R bit is not
set).
off-link Enter the keywords off-link to advertise the prefix without
stating to recipients that the prefix is either on-link or off-
link.
valid-lifetime |
infinite
Enter the amount of time that the prefix is advertised, or
enter infinite for an unlimited amount of time. The range
is from 0 to 4294967295. The default is 2592000. The
maximum value means that the preferred lifetime does not
expire for the valid-life time parameter.
preferred-
lifetime |
infinite
Enter the amount of time that the prefix is preferred, or enter
infinite for an unlimited amount of time. The range is
from 0 to 4294967295. The default is 2592000. The
maximum value means that the preferred lifetime and does
not expire.
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
By default, all prefixes configured as addresses on the interface are advertised. This
command allows control over the individual parameters per prefix; you can use the
default keyword to use the default parameters for all prefixes. If a prefix has been
configured with lifetime parameter values, the default values cannot be applied
using the
ipv6 nd prefix default no-autoconfig command.
680
IPv6 Basics

Table of Contents

Related product manuals