Dell MXL 10GbE - Maximum-Paths

Command
Modes
ROUTER ISIS
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Change the maximum LSP lifetime with this command. The maximum LSP lifetime
must always be greater than the LSP refresh interval.
The seconds parameter enables the router to keep LSPs for the specified length of
time. If the value is higher, the overhead is reduced on slower-speed links.
Related
Commands
lsp-refresh-interval — sets the link-state packet (LSP) refresh interval.
maximum-paths
Allows you to configure the maximum number of equal cost paths allowed in a routing table.
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths command.
Parameters
number Enter a number as the maximum number of parallel paths an
IP routing installs in a routing table. The range is from 1 to 16.
The default is 4.
Defaults 4
Command
Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
metric-style
To generate and accept old-style, new-style, or both styles of type, length, and values (TLV), configure a
router.
Syntax
metric-style {narrow [transition] | transition | wide
[transition]} [level-1 | level-2]
To return to the default values, use the no metric-style {narrow
[transition] | transition | wide [transition]} [level-1 |
level-2] command.
Intermediate System to Intermediate System (IS-IS)
821