Dell MXL 10GbE - Bgp Confederation Peers

bgp confederation peers
Specify the autonomous systems (ASs) that belong to the BGP confederation.
Syntax
bgp confederation peers as-number [...as-number]
To return to the default, use the no bgp confederation peers command.
Parameters
as-number Enter the AS number. The range is from 0 to 65535 (2 byte),
from 1 to 4294967295 (4 byte), or from 0.1 to 65535.65535
(dotted format).
...as-number (OPTIONAL) Enter up to 16 confederation numbers. The
range is from 0 to 65535 (2 byte), from 1 to 4294967295 (4
byte), or from 0.1 to 65535.65535 (dotted format).
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
All the routers in the Confederation must be 4 byte or 2 byte identified routers. You
cannot mix them.
The autonomous systems configured in this command are visible to the EBGP
neighbors. Each autonomous system is fully meshed and contains a few
connections to other autonomous systems.
After specifying autonomous systems numbers for the BGP confederation, recycle
the peers to update their configuration.
Related
Commands
bgp confederation identifier — configures a confederation ID.
bgp four-octet-as-support — enables 4-byte support for the BGP process.
bgp dampening
Enable BGP route dampening and configure the dampening parameters.
Syntax
bgp dampening [half-life reuse suppress max-suppress-time]
[route-map map-name]
To disable route dampening, use the no bgp dampening [half-life reuse
suppress max-suppress-time
] [route-map map-name] command.
Border Gateway Protocol IPv4 (BGPv4)
319