Dell MXL 10GbE - Distribute-List out

distribute-list out
Suppress network prefixes from being advertised in outbound updates.
Syntax
distribute-list prefix-list-name out [connected | bgp as number
| ospf process-id | rip | static]
To return to the default values, use the no distribute-list prefix-list-
name out [bgp as number connected | ospf process-id | rip |
static] command.
Parameters
prefix-list-
name
Specify the prefix list to filter prefixes in routing updates.
connected (OPTIONAL) Enter the keyword connected for directly
connected routing process.
ospf process-id (OPTIONAL) Enter the keyword ospf then the OSPF
process-ID number. The range is from 1 to 65535.
bgp as number (OPTIONAL) Enter the BGP then the AS Number. The range is
from 1 to 65535.
rip (OPTIONAL) Enter the keyword rip for RIP routes.
static (OPTIONAL) Enter the keyword static for user-configured
routing process.
Defaults Not configured.
Command
Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
You can assign a name to a routing process so a prefix list IS applied to only the
routes derived from the specified routing process.
Related
Commands
• distribute-list in — filters the networks received in updates.
• redistribute — redistributes routes from one routing domain to another routing
domain.
distribute-list redistributed-override
Suppress flapping of routes when the same route is redistributed into IS-IS from multiple routers in the
network.
Syntax
distribute-list redistributed-override in
802
Intermediate System to Intermediate System (IS-IS)