Dell MXL 10GbE User Manual

Field Description
TSA Transmission scheduling algorithm used by the priority
group: Enhanced Transmission Selection (ETS).
BW Percentage of bandwidth allocated to the priority group.
PFC PFC setting for the priority group: On (enabled) or Off.
Priorities 802.1p priorities configured in the priority group.
Example
Dell# show qos dcb-map dcbmap2
State :Complete
PfcMode:ON
--------------------
PG:0 TSA:ETS BW:50 PFC:OFF
Priorities:0 1 2 4 5 6 7
PG:1 TSA:ETS BW:50 PFC:ON
Priorities:3
Related
Commands
dcb-map — creates a DCB map to configure PFC and ETS parameters and applies
the PFC and ETS settings on Ethernet ports.
DCB Command
The following DCB command is supported on the FC Flex IO module installed in the MXL 10/40GbE
Switch platform.
dcb-enable
Enable data center bridging.
Syntax
dcb enable
To disable DCB, use the no dcb enable command.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.3(0.0) Introduced on the FC Flex IO module installed in the MXL
10/40GbE Switch
Usage
Information
DCB is not supported if you enable link-level flow control on one or more
interfaces.
FC Flex IO Modules
1377

Dell MXL 10GbE Specifications

General

Data Transfer Rate	10 Gbps per port
Switching Capacity	1.28 Tbps
Connectivity Technology	Wired
Model	MXL 10GbE
Type	Switch
Power Supply	Dual hot-swappable power supplies
Management	CLI, Web-based GUI, SNMP
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	10% to 90% non-condensing
Dimensions	17.3 x 17.4 x 1.7 inches (43.9 x 44.2 x 4.3 cm)