Dell MXL 10GbE - Redistribute Ospf

static
Enter the keyword static to redistribute manually
configured routes.
These routes are treated as incomplete routes.
route-map
map-name
(OPTIONAL) Enter the keyword route-map then the name
of an established route map.
Only the following ROUTE-MAP mode commands are
supported:
• match ip address
• set metric
• set tag
If the route map is not configured, the default is deny (to
drop all routes).
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
With the Dell Networking OS version 8.3.1.0 and later, you can use the
redistribute command to advertise the IGP cost as the MED on redistributed
routes. When you set the route-map with metric-type internal and applied
outbound to an EBGP peer/peer-group, the advertised routes corresponding to
those peer/peer-groups have the IGP cost set as MED.
If you do not configure the default-metric command, in addition to the
redistribute command, or there is no route map to set the metric, the metric
for redistributed static and connected is “0”.
To redistribute the default route (0.0.0.0/0), configure the neighbor default-
originate command.
Related
Commands
neighbor default-originate — injects the default route.
redistribute ospf
Redistribute OSPF routes into BGP.
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match
internal]] [route-map map-name]
Border Gateway Protocol IPv4 (BGPv4)
359