Dell MXL 10GbE - Access-Class

NOTE: Also refer to the Commands Common to all ACL Types section.
access-class
Apply a standard ACL to a terminal line.
Syntax
access-class access-list-name
Parameters
access-list-
name
Enter the name of a configured Standard ACL, up to 140
characters.
Defaults Not configured.
Command
Modes
LINE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
clear counters ip access-group
Erase all counters maintained for access lists.
Syntax
clear counters ip access-group [access-list-name]
Parameters
access-list-
name
(OPTIONAL) Enter the name of a configured access-list, up
to 140 characters.
Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ip access-group
Apply an egress IP ACL to an interface.
Syntax
ip access-group access-list-name {in | out} [implicit-permit]
[vlan
vlan-id]
Parameters
access-list-
name
Enter the name of a configured access list, up to 140
characters.
144
Access Control Lists (ACL)