Dell MXL 10GbE - Capture Bgp-Pdu Neighbor

To return to the default setting, use the no bgp soft-reconfig-backup
command.
Defaults Off
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you enable soft-reconfiguration for a neighbor and you execute the clear
ip bgp soft in command, the update database stored in the router is replayed
and updates are re-evaluated. With this command, the replay and update process is
triggered only if route-refresh request is not negotiated with the peer. If the
request is indeed negotiated (after executing the
clear ip bgp soft in
command), BGP sends a route-refresh request to the neighbor and receives all of
the peer’s updates.
Related
Commands
clear ip bgp — activates inbound policies without resetting the BGP TCP session.
capture bgp-pdu neighbor
Enable capture of an IPv4 BGP neighbor packet.
Syntax
capture bgp-pdu neighbor ipv4-address direction {both | rx |
tx}
To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-
pdu neighbor ipv4-address command.
Parameters
ipv4-address Enter the IPv4 address of the target BGP neighbor.
direction {both
| rx | tx}
Enter the keyword direction and a direction — either rx
for inbound, tx for outbound, or both.
Defaults Not configured.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
capture bgp-pdu max-buffer-size — specifies a size for the capture buffer.
show capture bgp-pdu neighbor — displays BGP packet capture information.
Border Gateway Protocol IPv4 (BGPv4)
327