Dell MXL 10GbE - Ip Name-Server

Usage
Information
To avoid denial of service (DOS) attacks, keep the number of fragments allowed for
re-assembly low.
ip name-server
Enter up to six IPv4 addresses of name servers. The order you enter the addresses determines the order
of their use.
Syntax
ip name-server ipv4-address [ipv4-address2...ipv4-address6]
To remove a name server, use the no ip name-server ip-address command.
Parameters
ipv4-address Enter the IPv4 address, in dotted decimal format, of the
name server to be used.
ipv4-address2...
ipv4-address6
(OPTIONAL) Enter up five more IPv4 addresses, in dotted
decimal format, of name servers to be used. Separate the
addresses with a space.
Defaults No name servers are configured.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The system does not support sending DNS queries over a VLAN. DNS queries are
sent out on all other interfaces, including the Management port.
ip proxy-arp
Enable proxy ARP on an interface.
Syntax
ip proxy-arp
To disable proxy ARP, use the no ip proxy-arp command.
Defaults Enabled.
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
IPv4 Routing
631