Dell MXL 10GbE - Show Dot1 X Cos-Mapping Interface

Defaults 30 seconds
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
show dot1x cos-mapping interface
Display the CoS priority-mapping table the RADIUS server provides and applies to authenticated
supplicants on an 802.1X-enabled system.
Syntax
show dot1x cos-mapping interface interface [mac-address mac-
address]
Parameters
interface Enter one of the following keywords and slot/port or number
information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Fast Ethernet interface, enter the keyword
FastEthernet then the slot/port information.
• For a Ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
mac-address (Optional) MAC address of an 802.1X-authenticated
supplicant.
Defaults none
Command
Modes
• EXEC
• EXEC privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To display CoS mapping information only for the specified supplicant, enter a
supplicant’s MAC address using the mac-address option.
You can display the CoS mapping information applied to traffic from authenticated
supplicants on 802.1X-enabled ports that are in Single-Hot, Multi-Host, and Multi-
Supplicant authentication modes.
Example
Dell#show dot1x cos-mapping interface tengigabitethernet 0/32
802.1p CoS re-map table on Te 0/32:
----------------------------------
Dot1p Remapped Dot1p
802.1X
135