Dell MXL 10GbE - Neighbor Distribute-List

Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
neighbor distribute-list
Distribute BGP information via an established prefix list.
Syntax
neighbor {ip-address | peer-group-name} distribute-list prefix-
list-name {in | out}
To delete a neighbor distribution list, use the no neighbor {ip-address |
peer-group-name} distribute-list prefix-list-name {in | out}
command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group to apply the distribute list
filter to all routers in the peer group.
prefix-list-
name
Enter the name of an established prefix list.
If the prefix list is not configured, the default is permit (to
allow all routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Other BGP filtering commands include: neighbor filter-list, ip as-path
access-list
, and neighbor route-map.
Related
Commands
neighbor route-map — assigns a route map to a neighbor or peer group.
342
Border Gateway Protocol IPv4 (BGPv4)