Dell MXL 10GbE - Vlt Domain

vlt domain
Enable VLT on a switch, configure a VLT domain, and enter VLT-domain configuration mode.
Syntax
vlt domain domain-id
Parameters
domain-id Enter the Domain ID number. Configure the same domain ID
on the peer switch. VLT uses the domain ID to automatically
create a VLT MAC address for the domain. The range of
domain IDs is from 1 to 1000.
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
vlt-peer-lag port-channel
Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to
an attached device.
Syntax
vlt-peer-lag port-channel id-number
Parameters
id-number Enter the port-channel number that connects to another
port channel in the VLT peer. The range is from 1 to 128.
Defaults Not configured.
Command
Modes
INTERFACE PORT-CHANNEL
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
show vlt private-vlan
Display the association of private VLAN (PVLAN) with the VLT LAG. You can configure VLT peer nodes in a
PVLAN on the MXL switch.
Syntax
show vlt private-vlan
Command
Modes
EXEC
Command
History
Version 9.3(0.0) Introduced on the MXL 10/40GbE Switch IO Module
platform.
Virtual Link Trunking (VLT)
1343