Dell MXL 10GbE - Neighbor Activate

Parameters
ebgp Enter the keyword ebgp to enable multipath support for
External BGP routes.
ibgp Enter the keyword ibgp to enable multipath support for
Internal BGP routes.
number Enter a number as the maximum number of parallel paths.
The range is from 1 to 16. The default is 1.
Defaults 1
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you enable this command, use the capture bgp-pdu max-buffer-size
command to recompute the best path.
neighbor activate
This command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI.
Syntax
neighbor {ipv6-address | peer-group-name} activate
To disable, use the no neighbor {ipv6-address | peer-group-name}
activate command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group-
name
Identify a peer group by name.
activate Enter the keyword activate to enable the identified
neighbor or peer group in the new AFI/SAFI.
Defaults Disabled.
Command
Modes
ROUTER BGPV6-ADDRESS FAMILY
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
IPv6 Border Gateway Protocol (IPv6 BGP)
721