Dell MXL 10GbE - Debug Ip Bgp Keepalives

peer-group
peer-group-
name
(OPTIONAL) Enter the keyword peer-group then the name
of the peer group.
in (OPTIONAL) Enter the keyword in to view only events on
inbound BGP messages.
out (OPTIONAL) Enter the keyword out to view only events on
outbound BGP messages.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To remove all configured debug commands for BGP, enter the no debug ip bgp
command.
debug ip bgp keepalives
Display information about BGP keepalive messages.
Syntax
debug ip bgp [ip-address | peer-group peer-group-name]
keepalives [in | out]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name] keepalives [in | out] command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group
peer-group-
name
(OPTIONAL) Enter the keyword peer-group then the name
of the peer group.
in (OPTIONAL) Enter the keyword in to view only inbound
keepalive messages.
out (OPTIONAL) Enter the keyword out to view only outbound
keepalive messages.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Border Gateway Protocol IPv4 (BGPv4)
333