Dell MXL 10GbE - Advertise Dot3-Tlv

Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
protocol lldp (Configuration) — enables LLDP globally.
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
show running-config lldp — displays the LLDP running configuration.
advertise dot3-tlv
Advertise dot3 TLVs (Type, Length, Value).
Syntax
advertise dot3-tlv {max-frame-size}
To remove advertised dot3-tlv, use the no advertise dot3-tlv {max-frame-
size} command.
Parameters
max-frame-
size
Enter the keywords max-frame-size to advertise the dot3
maximum frame size.
Defaults none
Command
Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
advertise management-tlv
Advertise management TLVs (Type, Length, Value).
Syntax
advertise management-tlv {system-capabilities | system-
description | system-name}
To remove advertised management TLVs, use the no advertise management-
tlv {system-capabilities | system-description | system-name}
command.
866
Link Layer Discovery Protocol (LLDP)