storm-control unknown-unicast (Interface)
Configure percentage of unknown-unicast traffic allowed on an MXL switch interface (ingress only).
Syntax
storm-control unknown-unicast [packets_per_second in]
To disable unknown-unicast storm control on the interface, use the no storm-
control unknown-unicast [packets_per_second in] command.
Parameters
packets_per_se
cond
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554431.
Defaults none
Command
Modes
INTERFACE (conf-if-interface-slot/port)
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Storm Control
1269
To Next Page
Loading...
