Dell MXL 10GbE - Ip Igmp Query-Max-Resp-Time

ip igmp query-max-resp-time
Set the maximum query response time advertised in general queries.
Syntax
ip igmp query-max-resp-time seconds
To return to the default values, use the no ip igmp query-max-resp-time
command.
Parameters
seconds Enter the number of seconds for the maximum response
time. The range is from 1 to 25. The default is 10 seconds.
Defaults 10 seconds
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ip igmp version
Manually set the version of the router to IGMPv2 or IGMPv3.
Syntax
ip igmp version {2 | 3}
Parameters
2 Enter the number 2 to set the IGMP version number to
IGMPv2.
3 Enter the number 3 to set the IGMP version number to
IGMPv3.
Defaults 2 (that is, IGMPv2)
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ip igmp snooping enable
Enable IGMP snooping on all or a single VLAN. This command is the master on/off switch to enable IGMP
snooping.
Syntax
ip igmp snooping enable
To disable IGMP snooping, use the no ip igmp snooping enable command.
548
Internet Group Management Protocol (IGMP)