Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#clear counters
Clear counters on all interfaces [confirm]
Related
Commands
mac learning-limit — allows aging of MACs even though a learning-limit is
configured or disallow station move on learned MACs.
show interfaces — displays information on the interfaces.
description
Assign a descriptive text string to the interface.
Syntax
description desc_text
To delete a description, use the no description command.
Parameters
desc_text Enter a text string up to 240 characters long. To use special
characters as a part of the description string, you must
enclose the whole string in double quotes.
Defaults none
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Important Points to Remember:
• Spaces between characters are not preserved after entering this command
unless you enclose the entire description in quotation marks (“desc_text”).
• Entering a text string after the description command overwrites any previous
text string that you previously configured as the description.
• The shutdown and description commands are the only commands that you
can configure on an interface that is a member of a port-channel.
• Use the show interfaces description command to display descriptions
configured for each interface.
Related
Commands
show interfaces description — displays the description field of the interfaces.
1464
PMUX Mode of the MXL 10/40GbE Switch I/O Module
To Next Page
Loading...
