Dell MXL 10GbE - Ipv6 Multicast Commands

Usage
Information
Network administrators use static mroutes to control the reach-ability of the
multicast sources. If a PIM-registered multicast source is reachable using static
mroute as well as unicast route, the distance of each route is examined and the
route with shorter distance is the one the PIM selects for reach-ability.
NOTE: The default distance of mroutes is zero (0) and is CLI configurable on a
per route basis.
Example
Dell#show ip rpf
RPF information for 10.10.10.9
RPF interface: Gi 3/4
RPF neighbor: 165.87.31.4
RPF route/mask: 10.10.10.9/255.255.255.255
RPF type: unicast
IPv6 Multicast Commands
The following section contains the IPv6 multicast commands.
debug ipv6 mld_host
Enable the collection of debug information for MLD host transactions.
Syntax
[no] debug ipv6 mld_host [int-count | interface type] [slot/
port-range]
To discontinue collection of debug information for the MLD host transactions, use
the no debug ipv6 mld_host command.
Parameters
int-count Enter the keyword count to indicate the number of required
debug messages.
interface type Enter the following keywords and slot/port information:
• For a 10G Ethernet interface, enter the keyword
tengigabitethernet then the slot/port information.
• For a 40G interface, enter the keyword fortyGigE then
the slot/port information.
• For a management interface, enter the keyword
managementinterface then the slot/port information.
• For a port-channel interface, enter the keywords port-
channel
then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
slot/port information.
Default Disabled
918
Multicast