NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
peer-group
peer-group-
name
Enter the keywords peer-group then the name of the peer
group.
in (OPTIONAL) Enter the keyword in to view only information
on inbound BGP routes.
out (OPTIONAL) Enter the keyword out to view only information
on outbound BGP routes.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To view information on both incoming and outgoing routes, do not include the in
and out parameters in the debugging command. The in and out parameters
cancel each other; for example, if you enter debug ip bgp in and then enter
debug ip bgp out, you do not see information on the incoming routes.
Entering a no debug ip bgp command removes all configured debug
commands for BGP.
Related
Commands
debug ip bgp events — views information about BGP events.
debug ip bgp keepalives — views information about BGP keepalives.
debug ip bgp notifications — views information about BGP notifications.
debug ip bgp updates — views information about BGP updates.
debug ip bgp events
Allows you to view information on local BGP state changes and other BGP events.
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name] events
[in | out]
To disable debugging, use the no debug ip bgp ipv6-address | peer-
group peer-group-name] events command.
Parameters
ipv6-address (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
then the prefix length in the /x format. The range is from /0
to /128.
714
IPv6 Border Gateway Protocol (IPv6 BGP)
To Next Page
Loading...
