Dell MXL 10GbE - Clear Lldp Neighbors

clear lldp neighbors
Clear LLDP neighbor information for all interfaces or a specific interface.
Syntax
clear lldp neighbors {interface}
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
debug lldp interface
To display timer events, neighbor additions or deletions, and other information about incoming and
outgoing packets, enable LLDP debugging.
Syntax
debug lldp interface {interface | all}{events | packet {brief |
detail} {tx | rx | both}}
To disable debugging, use the no debug lldp interface {interface |
all}{events} {packet {brief | detail} {tx | rx | both}}
command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
all (OPTIONAL) Enter the keyword all to display information
on all interfaces.
events (OPTIONAL) Enter the keyword events to display major
events such as timer events.
1498
PMUX Mode of the MXL 10/40GbE Switch I/O Module