Dell MXL 10GbE - Ip Ospf Transmit-Delay

This interval must be greater than the expected round-trip
time for a packet to travel between two routers.
Defaults 5 seconds
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Set the time interval to a number large enough to prevent unnecessary
retransmissions. For example, the interval must be larger for interfaces connected
to virtual links.
ip ospf transmit-delay
To send a link state update packet on the interface, set the estimated time elapsed.
Syntax
ip ospf transmit-delay seconds
To return to the default value, use the no ip ospf transmit-delay command.
Parameters
seconds Enter the number of seconds as the interval between
retransmission. The range is from 1 to 3600. The default is 1
second.
This value must be greater than the transmission and
propagation delays for the interface.
Defaults 1 second
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
log-adjacency-changes
To send a Syslog message about changes in the OSPF adjacency state, set the system.
Syntax
log-adjacency-changes
To disable the Syslog messages, use the no log-adjacency-changes
command.
944
Open Shortest Path First (OSPFv2 and OSPFv3)