Dell MXL 10GbE User Manual

Defaults Disabled (that is, the interface does not receive directed broadcast packets)
Command
Modes
INTERFACE
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ip domain-list
Configure names to complete unqualified host names.
Syntax
ip domain-list name
To remove the name, use the no ip domain-list name command.
Parameters
name Enter a domain name to be used to complete unqualified
names (that is, incomplete domain names that cannot be
resolved).
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To configure a list of possible domain names, configure the ip domain-list
command up to six times.
If you configure both the ip domain-name and ip domain-list commands,
the software tries to resolve the name using the ip domain-name command. If
the name is not resolved, the software goes through the list of names configured
with the
ip domain-list command to find a match.
To enable dynamic resolution of hosts, use the following steps:
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command. To view a DNS-related
configuration, use the show running-config resolve command.
Related
Commands
ip domain-name — specifies a DNS server.
624
IPv4 Routing

Dell MXL 10GbE Specifications

General

Data Transfer Rate	10 Gbps per port
Switching Capacity	1.28 Tbps
Connectivity Technology	Wired
Model	MXL 10GbE
Type	Switch
Power Supply	Dual hot-swappable power supplies
Management	CLI, Web-based GUI, SNMP
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	10% to 90% non-condensing
Dimensions	17.3 x 17.4 x 1.7 inches (43.9 x 44.2 x 4.3 cm)