Defaults Not configured.
Command
Modes
VLT DOMAIN
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
peer-routing
Enable L3 VLT peer-routing. This command is applicable for both IPV6/ IPV4.
Syntax
peer-routing
To disable L3 VLT peer-routing, use the no peer-routing command.
Defaults Disabled.
Command
Modes
VLT DOMAIN (conf-vlt-domain)
Command
History
Version 9.4(0.0) Added the IPV6/IPV4 support on the MXL.
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
peer-routing-timeout
Configure the timeout for the software to wait before connecting to a VLT peer with a Down status. This
command is applicable for both IPV6/ IPV4.
Syntax
peer-routing-timeout value
To restore the default value, use the no peer-routing-timeout command.
Parameters
value Enter the timeout value in seconds. The range is from 1 to
65535. The default value is 0 (no timeout).
Command
Modes
VLT DOMAIN (conf-vlt-domain)
Command
History
Version 9.4(0.0) Added the IPV6/IPV4 support on the MXL.
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When the timer expires, the software checks to see if the VLT peer is now available.
If the VLT peer is not available, peer-routing is disabled on that peer.
1334
Virtual Link Trunking (VLT)
To Next Page
Loading...
