Dell MXL 10GbE - Show Running-Config Pim

Interface state: Interface, next-Hop, State/Mode
(*, 226.1.1.1), uptime 01:29:19, expires 00:00:52, RP
10.211.2.1, flags: SCJ
Incoming interface: GigabitEthernet 4/23, RPF neighbor
10.211.1.2
Outgoing interface list:
GigabitEthernet 8/0
(*, 226.1.1.2), uptime 00:18:08, expires 00:00:52, RP
10.211.2.1, flags: SCJ
Incoming interface: GigabitEthernet 4/23, RPF neighbor
10.211.1.2
Outgoing interface list:
GigabitEthernet 8/0
(*, 226.1.1.3), uptime 00:18:08, expires 00:00:52, RP
10.211.2.1, flags: SCJ
Incoming interface: GigabitEthernet 4/23, RPF neighbor
10.211.1.2
Outgoing interface list:
GigabitEthernet 8/0
(*, 226.1.1.4), uptime 00:18:08, expires 00:00:52, RP
10.211.2.1, flags: SCJ
Incoming interface: GigabitEthernet 4/23, RPF neighbor
10.211.1.2
Outgoing interface list:
GigabitEthernet 8/0
show running-config pim
Display the current configuration of PIM-SM snooping.
Syntax
show running-config pim
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show running-config pim
!
ip pim snooping enable
Related
Commands
ip pim sparse-mode — enables PIM-SM snooping.
PIM-Sparse Mode (PIM-SM)
1033