Dell MXL 10GbE - Match Mac Dot1 P

Command
Modes
CLASS-MAP
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
Related
Commands
class-map — identifies the class map.
match mac dot1p
Configure a match criterion for a class map based on a dot1p value.
Syntax
match mac dot1p {dot1p-list}
Parameters
dot1p-list Enter a dot1p value. The range is from 0 to 7.
Defaults none
Command
Modes
CLASS-MAP
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
Related
Commands
class-map — identifies the class map.
match mac vlan
Configure a match criterion for a class map based on VLAN ID.
Syntax
match mac vlan number
Parameters
number Enter the VLAN ID. The range is from 1 to 4094.
Defaults none
Command
Modes
CLASS-MAP
Quality of Service (QoS)
1087