ip igmp version
Manually set the version of the router to IGMPv2 or IGMPv3.
Syntax
ip igmp version {2 | 3}
Parameters
2 Enter the number 2 to set the IGMP version number to
IGMPv2.
3 Enter the number 3 to set the IGMP version number to
IGMPv3.
Defaults 2 (that is, IGMPv2)
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.5.1.0 Introduced on the E-Series.
IGMP Snooping Commands
Dell Networking OS supports IGMP Snooping version 2 and 3 on all Dell Networking systems.
Important Points to Remember for IGMP Snooping
• Dell Networking OS supports version 1, version 2, and version 3 hosts.
• Dell Networking OS IGMP snooping implementation is based on IP multicast address (not based on
Layer 2 multicast mac address) and the IGMP snooping entries are in Layer 3 flow table not in Layer 2
forwarding information base (FIB).
• Dell Networking OS IGMP snooping implementation is based on draft-ietf-magma-snoop-10.
• Dell Networking OS supports IGMP snooping on JUMBO-enabled cards.
• IGMP snooping is not enabled by default on the switch.
• A maximum of 1800 groups and 600 VLAN are supported.
1486
PMUX Mode of the MXL 10/40GbE Switch I/O Module
To Next Page
Loading...
