Dell MXL 10GbE - Match Interface

match interface
To match routes whose next hop is on the interface specified, configure a filter.
Syntax
match interface interface
To remove a match, use the no match interface interface command.
Parameters
interface Enter the following keywords and slot/port or number
information:
• For the Loopback interface, enter the keyword loopback
then a number from zero (0) to 16383.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
Version
8.3.16.0
Introduced on the MXL 10/40GbE Switch IO Module.
Related
Commands
match ip address — redistributes routes that match an IP address.
match ip next-hop — redistributes routes that match the next-hop IP address.
match ip route-source — redistributes routes that match routes advertised by other
routers.
match metric — redistributes routes that match a specific metric.
match route-type — redistributes routes that match a route type.
match tag — redistributes routes that match a specific tag.
match ip address
To match routes based on IP addresses specified in an access list, configure a filter.
Syntax
match ip address prefix-list-name
202
Access Control Lists (ACL)