Dell MXL 10GbE - Show Ip Pim Interface

show ip pim interface
View information on the interfaces with IP PIM enabled.
Syntax
show ip pim interface
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the show ip pim interface command shown in the
following example.
Field Description
Address Lists the IP addresses of the interfaces participating in PIM.
Interface List the interface type, with either slot/port information or ID
(VLAN or Port Channel), of the interfaces participating in
PIM.
Ver/Mode Displays the PIM version number and mode for each
interface participating in PIM:
• v2 = PIM version 2
• S = PIM Sparse mode
Nbr Count Displays the number of PIM neighbors discovered over this
interface.
Query Intvl Displays the query interval for Router Query messages on
that interface (configured with ip pim query-interval
command).
DR Prio Displays the Designated Router priority value configured on
the interface (use the ip pim dr-priority command).
DR Displays the IP address of the Designated Router for that
interface.
Example
E600-7-RPM0#show ip pim interface
Address Interface Ver/ Nbr Query DR DR
Mode Count Intvl Prio
172.21.200.254 Gi 7/9 v2/S 0 30 1 172.21.200.254
172.60.1.2 Gi 7/11 v2/S 0 30 1 172.60.1.2
192.3.1.1 Gi 7/16 v2/S 1 30 1 192.3.1.1
192.4.1.1 Gi 13/5 v2/S 0 30 1 192.4.1.1
172.21.110.1 Gi 13/6 v2/S 0 30 1 172.21.110.1
172.21.203.1 Gi 13/7 v2/S 0 30 1 172.21.203.1
1024
PIM-Sparse Mode (PIM-SM)