Dell MXL 10GbE - Ip Ssh Connection-Rate-Limit

ip ssh connection-rate-limit
Configure the maximum number of incoming SSH connections per minute.
Syntax
ip ssh connection-rate-limit 1-10
Parameters
1-10 Enter the number of maximum numbers of incoming SSH
connections allowed per minute. The range is from 1 to 10
per minute. The default is 10 per minute.
Defaults 10 per minute
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ip ssh hostbased-authentication
Enable hostbased-authentication for the SSHv2 server.
Syntax
ip ssh hostbased-authentication enable
To disable hostbased-authentication for SSHv2 server, use the no ip ssh
hostbased-authentication enable command.
Parameters
enable Enter the keyword enable to enable hostbased-
authentication for SSHv2 server.
Defaults Disabled.
Command
Modes
CONFIGURATION
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If you enable this command, clients can log in without a password prompt. This
command provides two levels of authentication:
• rhost-authentication is done with the file specified in the ip ssh rhostfile
command.
• checking client host-keys is done with the file specified in the ip ssh pub-
key-file
command.
NOTE: Administrators must specify the two files (rhosts and pub-key-file)
to configure host-based authentication.
1186
Security