Dell MXL 10GbE - Netbios-Node-Type

Parameters
address Enter the address of the NETBIOS name server. You may
enter up to eight, in order of preference.
Defaults none
Command
Modes
DHCP <POOL>
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
netbios-node-type
Specify the NetBIOS node type for a Microsoft DHCP client. Dell Networking Operating System (OS)
recommends specifying clients as hybrid.
Syntax
netbios-node-type type
Parameters
type Enter the NETBIOS node type:
• Broadcast: Enter the keyword b-node.
• Hybrid: Enter the keyword h-node.
• Mixed: Enter the keyword m-node.
• Peer-to-peer: Enter the keyword p-node.
Defaults Hybrid
Command
Modes
DHCP <POOL>
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
network
Specify the range of addresses in an address pool.
Syntax
network network /prefix-length
Parameters
network/
prefix-length
Specify a range of addresses. Prefix-length range is from 17
to 31.
Defaults none
Dynamic Host Configuration Protocol (DHCP)
489