Dell MXL 10GbE - Show Npiv Devices

show npiv devices
Display the FCoE and FC devices currently logged in to an M I/O Aggregator and MXL 10/40GbE Switch
with the FC Flex IO module NPIV proxy gateway.
M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO module
Syntax
show npiv devices [brief]
Parameters
brief Displays an overview of current server CNA-fabric
connections over an M I/O Aggregator and MXL 10/40GbE
Switch with the FC Flex IO module NPIV proxy gateway.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.3(0.0) Introduced on the M I/O Aggregator and MXL 10/40GbE
Switch with the FC Flex IO module.
Usage
Information
Use the show npiv devices command to display information on the server CNA,
server-facing Ethernet and fabric-facing FC ports, and the SAN fabric in each
server-fabric connection over an M I/O Aggregator and MXL 10/40GbE Switch with
the FC Flex IO module NPIV proxy gateway.
The following table describes the show npiv devices brief output shown in
the example below.
Field Description
ENode-Intf M I/O Aggregator and MXL 10/40GbE Switch with the FC
Flex IO module Ethernet interface (slot/port) to which a
server CNA is connected.
ENode-WWPN Worldwide port name (WWPN) of a server CNA port.
FCoE-Vlan VLAN ID of the dedicated VLAN used to transmit FCoE traffic
to and from the fabric.
Fabric-Intf Fabric-facing Fibre Channel port (slot/port) on which FC
traffic is transmitted to the specified fabric.
Fabric-Map Name of the FCoE map containing the FCoE/FC
configuration parameters for the server CNA-fabric
connection.
LoginMethod Method used by the server CNA to log in to the fabric; for
example:
FLOGI - ENode logged in using a fabric login (FLOGI).
1418
FC Flex IO Modules