Dell MXL 10GbE - Isis Hello Padding

isis hello padding
Turn ON or OFF padding of hello PDUs from INTERFACE mode.
Syntax
isis hello padding
To return to the default, use the no isis hello padding command.
Defaults Padding of hello PDUs is enabled (ON).
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Hello PDUs are “padded” only when both the global and interface padding options
are ON. Turning either one OFF disables padding for the corresponding interface.
Related
Commands
hello padding — turns ON or OFF padding for LAN and point-to-point hello PDUs.
isis ipv6 metric
Assign metric to an interface for use with IPv6 information.
Syntax
isis ipv6 metric default-metric [level-1 | level-2]
To return to the default values, use the no ipv6 isis metric [default-
metric] [level-1 | level-2] command.
Parameters
default-metric Metric assigned to the link and used to calculate the cost
from each other router via the links in the network to other
destinations. You can configure this metric for Level 1 or
Level 2 routing. The range is from 0 to 16777215. The default
is 10.
level-1 (OPTIONAL) Enter the keywords level-1 to configure the
shortest path first (SPF) calculation for Level 1 (intra-area)
routing. This value is the default.
level-2 (OPTIONAL) Enter the keywords level-2 to configure the
SPF calculation for Level 2 (inter-area) routing.
Defaults default-metric = 10; level-1 (if not otherwise specified)
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Intermediate System to Intermediate System (IS-IS)
813