Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
dot1x reauth-max
Configure the maximum number of times a port can reauthenticate before the port becomes
unauthorized.
Syntax
dot1x reauth-max number
To return to the default, use the no dot1x reauth-max command.
Parameters
number Enter the permitted number of reauthentications. The range
is from 1 to 10. The default is 2.
Defaults 2
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
dot1x server-timeout
Configure the amount of time after which exchanges with the server time-out.
Syntax
dot1x server-timeout seconds
To return to the default, use the no dot1x server-timeout command.
Parameters
seconds Enter a time-out value in seconds. The range is from 1 to
300, where 300 is implementation dependant. The default is
30.
Defaults 30 seconds
Command
Modes
INTERFACE
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you configure the dot1x server-timeout value, take into account the
communication medium used to communicate with an authentication server and
the number of RADIUS servers configured. Ideally, the dot1x server-timeout
802.1X
133
To Next Page
Loading...
