Dell MXL 10GbE - Show Ip Dhcp Client Statistics

• For a 40-GigabitEthernet Ethernet interface, enter
FortyGigabitEthernet then the slot/port numbers;
for example, fortygigabitethernet 0/2.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
When you enter the renew dhcp command, a new dynamic IP address is acquired
on the specified Ethernet interface for the renewed lease time.
To display the currently configure dynamic IP address and lease time, enter the
show ip dhcp lease command.
show ip dhcp client statistics
Display DHCP client statistics, including the number of DHCP messages sent and received on an
interface.
Syntax
show ip dhcp client statistics {all | interface type slot/port}
Parameters
all Display DHCP client statistics on all DHCP client-enabled
interfaces on the switch.
interface type
slot/port
Display DHCP client statistics on the specified interface.
• For a 10-GigabitEthernet Ethernet interface, enter
TenGigabitEthernet then the slot/port numbers; for
example, tengigabitethernet 1/3.
• For a 40-GigabitEthernet Ethernet interface, enter
FortyGigabitEthernet then the slot/port numbers;
for example,
fortygigabitethernet 0/2.
Defaults none
Command
Modes
EXEC Privilege
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Dynamic Host Configuration Protocol (DHCP)
495