Dell MXL 10GbE - Debug Ip Bgp

Parameters
peer-group-
name
Enter the peer group name to reset the BGP sessions within
that peer group.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
debug ip bgp
Display all information on BGP, including BGP events, keepalives, notifications, and updates.
Syntax
debug ip bgp [ip-address | peer-group peer-group-name] [in |
out]
To disable all BGP debugging, use the no debug ip bgp command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group
peer-group-
name
Enter the keywords peer-group then the name of the peer
group to debug.
in (OPTIONAL) Enter the keyword in to view only information
on inbound BGP routes.
out (OPTIONAL) Enter the keyword out to view only information
on outbound BGP routes.
Command
Modes
EXEC Privilege
Command
History
Version 9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
To view information on both incoming and outgoing routes, do not include the in
and out parameters in the debugging command. The in and out parameters
cancel each other; for example, if you enter the
debug ip bgp in command and
then enter the debug ip bgp out command, you do not see information on the
incoming routes.
Entering a no debug ip bgp command removes all configured debug
commands for BGP.
Related
Commands
debug ip bgp events — views information about BGP events.
debug ip bgp keepalives — views information about BGP keepalives.
Border Gateway Protocol IPv4 (BGPv4)
331