Parameters
seconds Enter a number of seconds. The range is from 0 to 65535.
The default is zero (0) seconds.
centisecs
centisecs
Enter the keyword centisecs then the number of centisecs
in units of 25 centisecs. The range is from 0 to 65525 in
units of
25 centisecs.
Defaults zero (0) seconds
Command
Modes
VRRP
Command
History
Version 9.5(0.0) Introduced the support for centisecs on the MXL 10/40GbE
Switch.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
If a switch is a MASTER and you change the hold timer, disable and re-enable VRRP
for the new hold timer value to take effect.
Related
Commands
disable — disables a VRRP group.
preempt
To preempt or become the MASTER router, permit a BACKUP router with a higher priority value.
Syntax
preempt
To prohibit preemption, use the no preempt command.
Defaults Enabled (that is, a BACKUP router can preempt the MASTER router).
Command
Modes
VRRP
Command
History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
priority
Specify a VRRP priority value for the VRRP group. The VRRP protocol uses this value during the MASTER
election process.
Syntax
priority priority
To return to the default value, use the no priority command.
Virtual Router Redundancy Protocol (VRRP)
1349
To Next Page
Loading...
